XR2206 High Precision Signal Generator DIY Kit Sine Triangle Square Waves 1Hz-1MHz Frequency Range, Specification: Welding

1. Power supply voltage: 9-12VDC input2. Waveforms: square, sine and triangle waves3. Impedance: about 600 ohms4. Frequency: 1Hz-1MHz5. Sine wave:-Amplitude: 0-3V (9V DC input)-Distortion: Less than 1 percent (at 1kHz)-Flatness: +0.05dB 1Hz-100kHz6. Square wave:-Amplitude: 8V (no load 9V DC input)-Rise Time: Less than 50ns (at 1kHz)-Fall time: less than 30ns (at 1kHz)-Symmetry: Less than 5 percent (at 1kHz)7. Triangle wave:-Amplitude: 0-3V (at 9V DC input) -Linearity: Less than 1 percent (up to 100kHz) 10mACircuit features:1. It can generate sine wave, triangle wave and square wave2. Frequency can be from 1HZ-1MHZ, frequency, amplitude adjustable3. 5-bit precision resolution, frequency adjustment with coarse and fine tuning4. Wide range of power supply, can use external power supply 9-12V or 9V battery 5. All direct insertion components, the number of components is small, simple installation and commissioningPrecautions for soldering and mounting, please follow the steps below:1. Components are welded to the front panel, from low to high principle, that is, the first welding low-end components, such as capacitors, resistors, diodes, etc.2. Welding IC sockets, terminals, and finally the power socket, adjustable potentiometer3. Behind the use of diagonal pliers to try to cut short pinsDebugging steps:1. After completing the welding of the IC, XR2206, pay attention to the direction of the IC, the insertion may damage the chip2. Check whether the IC is reverse, such as reverse, please correct in a timely manner3. Insert the power supply, the power supply is 5.5 x 2.1 port, inside and outside the negative pole, the power supply voltage is 9-12V, more than 12V waveform may be unstableSteps for use:1. Insert J1 jumper cap, SIN/TRI blue terminal output sine wave (note that J1, J2 can only be inserted into one of the)2. Insert J2 jumper cap, SIN/TRI blue terminal output triangle wave (note that J1, J2 can only be inserted into one)3. SQU blue terminal outputs pulse4. AMP: sine wave, triangle amplitude adjustment5. FINE: frequency fine-tuning6. Coarse: frequency coarse adjustment