WS2812 LED Module Decoder Built-in Buzzer for Pixhawk / Pixhack / Pixraptor Flight Controller

WS2812 LED Module Decoder Built-in Buzzer for Pixhawk / Pixhack / Pixraptor Flight Controller Instuction: LED Modul decoder which decodes the IC control signals for the external LED and controls six of WS2812 LED. Specification: LED Modul can be added by connecting it to the flight controller's I2C port. Because most users use a Ublox GPS and Compass module, an I2C splitter is recommended. If using a Pixhawk flight controller, once connected the LED on the center of the board may no longer light up (recent versions of ArduPilot will light up both LEDs). Mounting the LED Module The sound from the buzzer can impact the accelerometers if placed too close to the flight controller which can lead to poor altitude hold performance when the buzzer is activated. The buzzer should ideally be mounted at least 5cm away from the flight controller and the speaker (i.e. the open hole) should not be pointing directly at the flight controller. External LED of WS2812 Led Strips Solder a 4-pin IC DF13-cable to WS2812 Led Strip. The WS2812 Led Strips need 5V. Never power any amount of WS2812 Led Strip from the flight controller or the flight controller's power supply. One WS2812 Led Strip can pull up to 60mA. That accumulates pretty quickly into significant currents when using many. Package Included: 1x LED Module 1x SH1.25 6p to 4p IIC port & 2p Buzzer wire