W5500 Ethernet Shield Ethernet Controller Expansion Board IoT Solution built-in Grove Connectors for I2C and UART

Specification The W5500 Ethernet Shield v1 0 can be used to provide your projects with internet connectivity W5500 enables users to have the Internet connectivity in their applications just by using the single chip in which TCP IP stack 10 100 Ethernet MAC and PHY embedded The shield also have two Grove connectors and a microSD card socket to support projects which require storing large amounts of data from Grove sensor The RJ45 port Where the Ethernet cable is connected to is low enough to allow you to stack more shields on top of this one if needed Features Supports Hardwired TCP IP Protocols TCP UDP ICMP IPv4 ARP IGMP PPPoESupports 8 independent sockets simultaneouslySupports Power down modeSupports Wake on LAN over UDPSupports High Speed Serial Peripheral Interface SPI MODE 0 3 Internal 32Kbytes Memory for TX RX Buffers10BaseT 100BaseTX Ethernet PHY embeddedSupports Auto Negotiation Full and half duplex 10 and 100 based Not supports IP Fragmentation3 3V operation with 5V I O signal toleranceLED outputs Full Half duplex Link Speed Active Micro SD card socketGrove connector for I2C and UARTDimensions 100mm x65mm x30mmDocumentations W5500 Ethernet Shield in Eagle formatW5500 Ethernet Shield Schematic in PDF formatW5500 Ethernet Shield PCB in PDF formatW5500 Ethernet Shield LibraryW5500 Ethernet Shield Datasheet pdfwikiPackage includes 1 x W5500 Ethernet Shield