TechLogix TL-IPFO-R01 1000' HDMI 2.0 AV Over IP Decoder/Receiver

Forget traditional HDMI, fiber optic and twisted pair matrix switchers, TechLogix IPFO AV over IP encoders and decoders allow an unlimited number of sources to be connected to an unlimited number of destinations via a standard 10G Ethernet switch. Many manufacturers offer AV over IP solutions and many manufacturers offer control products, but few manufacturers put both together into a seamless, easy-to-integrate and easy-to-operate system. The TechLogix IPFO system combines AV over IP encoders and decoders with proprietary software which eliminates the need for extensive programming and third-party control system drivers. Plus, the IPFO system doesn't require proprietary network switches and runs seamlessly on a standard data network without slowing down traffic.The IPFO system leverages Aptovision technology to transmit zero-latency 4K at 60 4:4:4 HDMI up to 300m (1000') over fiber optic cabling using a 10G network and a simple swap of the SFP+ module allows signal extension up to 30km using single mode cable. Multiple encoders and decoders can be blended into a seamless, any-input-to-any-output system using TechLogix TLXpress software.Setup is simple: simply place an encoder at each source, place a decoder at each display and place a single IPFO control box running TLXpress software somewhere on the network. The IPFO control box automatically identifies all of the IPFO components and the TLXpress software profiles them to the sources and destinations for quick preset creation. Integrators don't need to worry about time consuming driver creation - they just trigger presets with a single command from a third-party control system.The TLXpress platform provides an added benefit of being drag-and-drop architecturally based, allowing virtually hundreds of encoders and decoders to be identified and programmed in minutes, including preset routing which can be triggered by a third-party control system. Additional system features include seamless switching among sources, embedded bi-directional IR and RS232 control, built-in 1G Ethernet pass-through, built-in video wall processing, audio embedding and de-embedding, HDMI and DisplayPort inputs with autoswitching on the encoders and HDMI 2.0/HDCP 2.2 compliancy.For a point to point installation, the TL-IPFO-TX01 and TL-IPFO-RX01 only need a duplex OM3 cable with LC connectors between the devices. For a matrix design, the system can be quickly configured and controlled with the TL-IPTP-CI control interface using the TLXpress software.