Shower Head Holder Wall Mounted Shower Head Holder Fixed Chrome

Shower Head Holder Wall Mounted Shower Head Holder Fixed Chrome Product parameters: Product name: shower bracket Material: ABS Installation hole distance: 5 cm Packing: Softcover Material shower bracket general-purpose PVC engineering resin with matching mounting screws. up and down this bracket is made of ABS composite material to the wall with chrome plating on the surface. Products include: 2x shower bracket Installation steps: 1. Measure the height you want to put and make a mark; 2. Make a hole in the wall with a hand drill tighten the screws and then put on the shower base which is very convenient. Use and maintenance of shower and faucet: The sprinkler has water for a long time due to water quality. Due to environmental factors a certain amount of scale and impurities will be generated inside the shower. The accumulation of scale and impurities to a certain extent may affect the comfort of your bathing. It even has a destructive effect on the shower so attention to proper maintenance and maintenance of the product. 1: Removal of scale: every six months or less remove the shower and place it in a small basin water the surface and inside of the shower with white vinegar and soak for 4-6 hours and then use a cotton rag Gently wipe the spout on the surface of the shower: After reinstalling the connector let the water for a while and wait for the white vinegar and scale to out with the water to or reduce the influence of the scale on the shower and have a certain sterilization effect. 2: Maintenance of the electroplating surface of the faucet: often wipe the electroplated surface of the shower with a and a little flour and then rinse with water to make the surface of the shower bright as new. Precautions: 1): Please attention to the safety of yourself and the product when disassembling and assembling the shower head: 2): Filter gaskets cannot be used with meshes that are too large or too fine. Too large may not have a filtering effect and too fine may affect the rate. The size of the filter is 40-60 mesh. 3): Do not use strong when removing scale so as not to cause to the shower surface. 4): Do not disassemble the showerhead for maintenance by yourself as improper disassembly will damage the appearance and internal structure of the product. 5): The ambient temperature of the showerhead should not 70C. High temperature and light will greatly the aging of the showerhead and shorten the service life of the showerhead. Therefore the installation of the shower head should be as far away as possible from the heat source of electric appliances such as Yuba. The shower head cannot be installed directly under the Yuba and the distance should be above 60cm.