Rolling Door Access Control Security Alarm Copy Copy Wireless Remote Control

Specification: Product Name: Remote Control Duplicator material: plastic Size: 6CM Working voltage: DC12V (excluding 27A battery) Working current: ≤ 8mA Operating frequency: 433MHz Modulation Mode: ASK (AM) Transmission power: ≤ 100 mW Launch distance: 100 m (proof) Encoding Type: Self-replicating Operating temperature: -10°C to +50°C Suitable for the following remote control IC modules (please check your original remote control before ordering) your remote control should also be a fixed code or a learning code. AX5326-3 PT2262 PT2260 EV1527 FP527 PT2242 HT600 HT680 HT6207 HT6010 HT6012 HT6014 AX5326 4 SMC918 PT2240 HT6013 HT6013.HT12D etc. Application areas: garage doors motorcycles car alarm products home security products short-range wireless remote control products industrial control products How to program: Step 1 – Delete the existing code for the remote copier 1) Press and hold the A and B buttons at the same time - the Led will flash 3 times 2) Keep pressing the A button and release the B button 3) Hold down the A button and press the B button 3 times the Led will start blinking Now press any key on the remote control the LED light is not on so the deletion of the code is successful; if the button is pressed the LED light is on indicating that the original code has not been deleted! Step 2 - Clone the original remote 1) Place the two remotes in a back-to-back position. Make sure they have a direct connection 2) Click and hold 1 button on the original remote and 1 key on the cloned remote. Keep holding until the led light flashes 2 times then 3 times and then goes to a steady state you have cloned successfully. (left click to follow above) If for some reason the clone doesn t move on it flashes 2 times which means the signal isn t going through move the remote slowly up and down until it gets to where it wants to go. Package Contents: 1 x Remote Control Duplicator Note: 1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. 2. Please allow slight manual measurement deviation for the data.