RadioMaster RP1 2.4GHz ExpressLRS ELRS Open-Source High Refresh Rate Low Latency Nano Receiver Built-in Wifi for Whoops

RadioMaster RP1 2 4GHz ExpressLRS ELRS Open Source High Refresh Rate Low Latency Nano Receiver Built in Wifi for Whoops RC Drones AirplaneThe RP1 and RP2 2 4GHz ELRS nano series receivers are open source receivers based on ExpressLRS The Nano receivers first developed by Jye Smith from the ExpressLRS development team feature ESP8285 MCU and SX1280 RF chip The RP1 has a UFL antenna socket for full range antenna use The RP2 has a built in ceramic antenna which is super light and small in size and ideal for racing The RP1 and RP2 feature WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built in WebUI with your PC or mobile phone Due to the low latency and high refresh rate RF module the RP1 and RP2 are ideal for FPV races or Long Range Suitable for Whoops drones and fixed wing models due to the ultra light and Nano size these receivers can fit just about anywhere Specification Brand RadiomasterItem RP1 Nano ExpressLRS 2 4ghz ReceiverType ISMAntenna 65mm 2 4ghz T AntennaMaximum receive refresh rate 500Hz F1000HzMinimum receiver refresh rate 25HzWorking voltage 5vWeight 2 2g Including antenna Dimension 13mm 11mm 3mmFirmware Version ExpressLRS v2 4 pre installedFW Target RadioMaster RP1 2 2400 RXBus interface CRSFBullet Point Improved PCB design is better for heat dissipation Upgraded rigid antenna with greater durability and performance LED on the top side of PCB Solder pads are improved and easier to solder to Pac