RF Nano V3.0 Micro USB Module ATmega328P QFN32 5V 16M CH340 Integrate NRF24l01+2.4G Wireless Imme For Arduino

Feature: 1. Creative products, RF-Nano-Board: Upgraded nano board for Arduino, The main chip is ATMEGA328P-MU QFN32, the latest bootloader (Arduino IDE 1.8.8) was burned down. It is fully compatible with the common nano board. RF-Nano-Board is PIN-PIN with Arduino Nano V3.0,and share the same codes. 2. More convenient for application: The RF-Nano-Board integrates an NRF24L01+ module with Arduino nano v3.0 board, which is very convenient for 2.4G wireless connect application. 3. High quality material and Technology: We used high quality PCB original material and Immersion Gold Technology to make sure every board has smooth edge and more reliable. 4. Super small volume design, more convenient to use: The PCB size is only 48mm*19mm, the pin is fully compatible with Nano V3.0,No Soldering needed. The micro usb port is more convenient to use. 5. RF-Nano-Board using CH340 chip to UART, you can download mac, windows, Linux three system drivers. Specification: Microcontroller ATmega328P Nrf24L01+ 2.4G wireless Architecture AVR Operating Voltage: 5 V Flash Memory: 32 KB of which 2 KB used by bootloader SRAM: 2 KB Clock Speed: 16 MHz Analog I/O Pins: 8 EEPROM: 1 KB DC Current per I/O Pins: 40 mA (I/O Pins) Input Voltage: 7-12 V Digital I/O Pins: 22 PWM Output: 6 Power Consumption: 19 mA Weight: 9g Parameter: It is fully compatible with the Arduino nano-v3.0 pin and its usage method BLE chip: TI CC2540 Work channel: 2.4G Transmission distance: 50m Supports AT directive to configure BLE Support USB virtual serial port, hardware serial port, BLE three-way transparent transmission Support master and slave switch Supports sending over 20byte. Supports iBeacons Interface: Micro-USB Input voltage: USB power supply, Vin6~12V, 5V MCU: ATmega328P-MU QFN32 Bootloader: Newest Arduino1.8.8 Pin: Two Lines 2.54mm-15Pin Size: 48mm x 19mm x 12mm Package includes: 1 x RF Nano board Note: Please use Arduino IDE 1.8.6 or higher version, First, install the CH340 driver, then follow this selection path in Arduino IDE: Tools - Board"Arduino Nano" Processor "ATmega328P" otherwise you'll find that you can't burn any program.