PreAsion Portable Electric Bending Machine Small Hand Held Steel Rebar Bender Machine 220V Steel Bending Angle Tool

Description： 1. The steel bars must be placed in a horizontal position. After 40-50 continuous bends please cool them before use (please combine the actual use conditions such as weather machine temperature etc.). 2. After every 300~500 times of bending tighten the bolts and screws especially the bolts of the sealing part between the tool holder and the cylinder block. How to use: 1. Please place the length of the bent steel bar on the bottom of the head frame and the push block according to the required length. 2. Clamp the rebar and turn on the switch. 3. The piston moves forward the steel bar is bent observe the bending angle with eyes then release the switch the motor stops running pull back the valve handle and the piston retreats. Note: 1.Do not use the machine to bend rebars that exceed the maximum bending size after bending dozens of bars please cool down before use! 2.After purchasing this machine please read the manual carefully the relevant precautions are listed in the manual Parameters: Voltage；220V Power：1100W Bending time:2-2.5s Minimum rebar size (bent to 90°):18MM Maximum rebar size:22MM Net weight:16kg warn: 1. Please use the bending machine with caution. If there is a drop or collision the frame may be deformed cracked or damaged. Be sure to fully check before use and then use it after confirming safety. When it is confirmed that there is an abnormality please check it immediately. 2. Carrying the product by the lead or pulling the lead out of the socket will damage the lead resulting in disconnection or short circuit. At the same time be careful not to let the lead wire come into contact with blades high-temperature objects chemicals etc. If the lead wire is damaged please stop the operation immediately and carry out inspection. 3. The fan of the bending machine is a necessary part to cool the motor please do not block it with dust. If it is blocked it will burn out due to excessive temperature. 4. Please clean up the machine frequently and keep it in the best condition. Especially the motor parts and switch parts wipe the dust before each use. Also always clean the lead wire to prevent it from deteriorating due to the action of oil or oily substances. 5. Please check the push block frequently so that it is always used in good condition. 6. This machine has a motor part so please do not use it in rain or snow. 7. Be sure to tighten the bolts and nuts after every 300-500 bends. Especially the bolts of the sealing part between the head frame and the cylinder block. 8. Please keep the bending machine and accessories in the following places: A. Places out of reach of children. B. Places where temperature and humidity do not change drastically. C. Avoid rain and places with high humidity. D. Places out of direct sunlight. E. Avoid placing it in places prone to fire or explosion and volatile substances. Item Include：190252 PreAsion Portable Electric Bending Machine Small Hand Held Steel Rebar Bender Machine 220V Steel Bending Angle Tool