Peeling Winder Power Tool Accessories Parallelizer Wire Twisting Connector Twister Power Drill Cable Connector Wire Twisting Tool Stripper Winder TO 1.5-4 SQUARE METERS

Two screwdrivers are included for manual tightening and peeling. Made of high-quality 45# stainless steel with good performance. The wire connector tool with 3/8 inch hex handle can be connected to impact drivers and electric drills. It is easy to operate and helps reduce repetitive sports injuries. The wire connector tool can be used not only for electric drills but also for manual use. The stranding tool can be twisted and stripped at the same time which helps to increase productivity and prevent finger soreness. Product Type: Wire Stripper Material: 45# steel Color: silver Instructions for use: Electric parallel: Prepare the hand drill and connect the liner to the hand drill. Insert three parallel wires separately fix the tail with a vise and install the threader and vise as much as possible. The three wires must be clamped. If not clamped the connection will be affected influences. Start the electric drill to start the electric drill and then slowly rotate the aligner. During the rotation align the aligner vigorously in the vise direction. After winding the aligner can be adjusted Loosen and remove the wires wires. Manual parallel: Measure the length of the strip to be peeled off. Put a lot of wires into the corresponding holes and clamp them in a vise. Press the parallelizer in the direction of the arrow to rotate and parallel. Do it in parallel. Note: Clamp the wires with pliers. The wires must be parallel and secure. The pliers are in close contact with the parallelizer. Package Included: 1 * Wire stripper