Leather Craft Edge Skiving Machine Leather Splitter Skiver Paring Tool DIY

【About this item】 shipping notice：Can not ship to Puerto Rico Alaska/Hawaii Brand：Unbranded MPN：Does Not Apply Color：Silver Material：Aluminum Suitable For：Leather skiving Size：165x145x118mm/6.5*5.7*4.6 inch Specifications Color: Silver Material: Aluminum Size: 165x145x118mm/6.5*5.7*4.6 inch Suitable For: Leather skiving Features - Upgrade folder for quick blade replacement mode change blades in one step. - Upgraded stainless steel wheel nylon wheel no longer worried about damage. -Flexibleas long as there is a small piece of flat work surface can be used. -easy installation all the parts after computer work planning laser cutting with precision. -The use of energy through the reasonable design of part Angle coordinate -Maintenance easy the whole machine adopts aluminum bracket stainless steel screws stainless steel holder don t have to worry about the rust problem.The most commonly used double-sided razor blade cutting tool and three holes blade support most of the industry. Installation step 1. Put into built-screw nut and the screw nut is inside. 2. Install rectangular connectors 3. Connect the two thick aluminum 4. Connect the two thin aluminum 5. Screwed into the screw can be fixed 6. Install the other rectangular connectors 7. Connect the beams and columns 8. Install Loading bay 9. Install the stainless steel round it recommended tightening the screws and non-rotating wheel to prevent slipping and hurt fingers;If you want to rotate feeding just loose screws 10. Use the longest screws fix the Loading bay 11. Install the blade and screw with a hexagonal wrench 12. Installed the semicircle base 13. Use G clamp fix on the machine table Note 1. Before use pls make sure that all screws are tightened and Aluminum will not shift and shake when we use force;Machine and work surface using G clamp to fix;Vertical and horizontal of aluminum is in good condition. 2. The peak mouth of blade and the surface of stainless steel round keep parallel before use 3. Viewed from the side the peak mouth of blade and the centerline of the wheel apart about 3mm because blade too far back lead to the leather get stuck and can t pull them 4. Blade clamp must tighten with a screwdriver and wrench. Packing Included 4 x bracket 1 x semicircle measuring tape 8 x Retention tab 5 x plastic cover 15 x screws 2 x wrench 1 x screwdriver 1 x G Clamp 1x Blade