INTBUYING Electric Wire Stripping Machine Automatic Bench-top Cable Wire Stripper for Scrap Copper Recycling Diameter 1.5-38mm

Specification: Model: SMS-38 Voltage: 110V Power: 370W Wire Stripping range: Φ1.5mm~ 38mm Measurement (L*W*H): 58*28*37cm Use notice 1.Comparing the cables/wires’ diameters with the feeding holes on the machine feeding the cables/wires one piece at one time. Before feeding the cables/wires please cut off the head of the cables/wires to avoid gaps caused to the blades. 2.On the output side if the cuts on the cables/wires are too deep please check below points: 1) Please adjust the handles on the input side screw down or loose them. (M12 handles) 2) Check whether the cables/wires on the right position as you feeding them. 3) Make sure the blades are sharp if not polish them with the oil stone. 3.On the output side if see the plastic (PVC) has been stripped but the copper wires can not been disgorged please check below 4 points: 1) polish the axis of the upside with the oil stone. 2) Check whether the springs are loose if yes screw down to make them tighten. 3) The diameter of the cables/wires are too small please adjust the space between the two axis to 0.3-0.6mm. 4) If the cables/wires you want to strip are hot also can not get the copper wires stripped out. 4.If the cables/wires were blocked in the axis please check below points: 1) If the springs on the press wheels are too tight loose them. 2) There are too much oil on the cables/wires please wipe it. 5.If see the blades tilted : 1) Check whether the center adjuster was loosed. 2) centering adjustment and adjust the screws of two sides of it. Make sure the cables/wires’ diameter are similar with the feeding holes large cables/wires in large feeding holes small cables/wires in small feeding holes flat cables/wires in flat feeding holes. Item included: 153082 INTBUYING Electric Wire Stripping Machine Automatic Bench-top Cable Wire Stripper for Scrap Copper Recycling Diameter 1.5-38mm