Holybro Pixhawk RPi CM4 Baseboard and PM03D Power Module ComboCompatible with RC Quadcopter Pixhawk 6X 5X Flight Contr

Notice NOT include Flight Controller ModuleRPi CM4 Introduction The Holybro Pixhawk RPi CM4 Baseboard can combine the Pixhawk FC module with the Raspberry Pi CM4 companion computer Purhcase seperately in on compact form factor with all the connections you need for development The Holybro Pixhawk RPi CM4 Baseboard can combine the Pixhawk FC module with the Raspberry Pi CM4companion computer Purhcase seperately in on compact form factor with all the connections you need for development It follows the Pixhawk Connector and Autopilot Bus Standard allow easy swap of FC Module with any FC that follows the Pixhawk Bus Standard The FC Module is internally connected to RPi CM4 through TELEM2 and can also be connected via ethernet with a external cable provided It is compatible with the Pixhawk 5X6X flight controller module Specification Holybro Pixhawk RPi CM4 BaseboardNotice Only baseboard like photo showed NOT include Flight Controller ModuleRPi CM4 PM03D Power ModuleMaximum input voltage 6S batteryPCB Cont Current Rating 90APCB Burst Current Rating 140A 60 Sec Max current sensing 164AConnectionsXT 60 for battery XT 30 for motorperipheral device battery voltage Solder pads in each corner battery voltage CLIK Mate 2 0mm for flight controller 5 2V 3A standalone BEC JST GH 4pin 5 2V 3A BEC shared with 5 2V triple row pin header 2x Triple row pin header 5 2V 3A BEC shared with JST GH 4pin 2x Triple row pin header 8V or 12V selectable by moving header