Holybro PM06 V2 10S Micro Power Module with XT60 Connector for RC Drone

Introduction This PM06 Power Module supplies clean 5 2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST GH cable along with integrated power distribution for 4 ESCs It comes with pre soldered wires capacitor and XT60 connector Specification Input voltage 2S 10SPCB Cont Current Rating 70APCB Burst Current Rating 120A 60 Sec Output DC 5 2V3A Max Ouput Max Power 18WVoltage Divider 18 182Amperes per Volt 36 364 Please Note The XT60 Plug and 12AWG wire that are pre soldered on the board is rating for 30A continuous current and 60A burst current 60 Seconds If a higher current is being used the plug type and wire size should be changed accordingly You can refer to this chartfor reference This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X6X Requires a digital PM like PM02D Mechanical Specification Dimensions 35x35x5mmMounting hole 30 5mm 30 5mmWeight 24gSetup guide for PX4Ardupilot can be found in the Holybro Doc here Package Included 1xPM06 board1x80mm XT60 connector wire pre soldered 1xElectrolytic capacito 220uF 63V pre soldered 1xJST GH 6pin cable