Goodhd Electric Heating Dual-purpose Tin Desoldering Soldering Suction Pump Power Tool

Details: * brand new and high quality *842A electric dual-purpose tin absorber has the characteristics of beautiful appearance novel structure easy to use clean tin absorption etc. by using it the components to be replaced can be easily removed from the circuit board without damaging the components and circuit board. The advantages of replacing integrated circuit multi foot switch etc. are more prominent. This tin absorber can be used as a general electric soldering iron It is a necessary tool for national defense scientific research communication aerospace computer radio television electronic professional maintenance personnel and the vast number of radio enthusiasts *Color: Blue Black (As Pictures Show) *Material: Plastic handle + stainless steel tube *Optional types: US(110V) EU(220V) How to Use: 1 110V / 220V POWER 30W 2 Turn on the power and preheat for 3-5 minutes 3 Push down the piston handle and clamp it. Align the front end of the solder iron nozzle with the solder joint of the component to be removed. When the solder melts press the control button and the solder will be sucked into the air cylinder 4 Two nozzles with different diameters are equipped for the tin aspirator which can be selected according to the thickness of component lead 5 When welding the same operation as using electric soldering iron 6 When disassembling the air cylinder press down the upper end of the air cylinder in the direction of the mark pull the air cylinder and the handle apart at the same time and the air cylinder can be separated. When disassembling the suction nozzle turn the suction nozzle anticlockwise to remove the suction nozzle Note: 1 Check whether the use voltage is consistent too high or too low voltage is not conducive to use 2 Before use tighten the nozzle and air cylinder to prevent air leakage otherwise the effect of tin absorption will be affected 3 Frequently remove the solder impurities entering the nozzle and air cylinder and add a little oil to the piston 4 After each use push the piston 3-4 times to remove the residual solder in the suction pipe so that the suction nozzle and the suction pipe are unblocked for the next use 5 It is forbidden to install and remove the electric heating parts of the tin aspirator after it is powered on 6 When the new tin aspirator is used for the first time it may smoke slightly due to the heating of the electric heating element which is a normal phenomenon and will disappear naturally in ten minutes 7 In the process of use a soldering iron base with natural heat dissipation structure must be used and placed in the soldering iron base 8 If the power cord is damaged it must be replaced by the manufacturer or its maintenance department or similar full-time personnel to avoid danger 9 This product has ground wire. It should be equipped with socket with contact. Please pay attention to the use to ensure safety Package Contents: 1*Soldering Suction Pump Note: 1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness. 2. Please allow slight manual measurement deviation for the data.