Garage Door Remote Control Cloning 4 Key Auto Car Duplicator Clone (315MHz)

Copy Duplicator Wireless Remote Control Universal Auto Car Garage Door Gate Opener Cloning 433MHz Transmitter Specification: Working voltage: DC 6V Operating current: 14mA Static current: 0mA Operating frequency: 315/433 (optional) Transmitting power: 10mW Launch distance: 100m/328ft (open environment) Product size: 69 * 36 * 15mm/2.7*1.4*0.6in Scope of use: reproduction and regeneration of wireless remote controls such as road gates garage doors cars / motorcycles etc. Application scope of copy remote controller: ordinary fixed code (chip types 2260 2262 2264) learning code (1527 2240) remote controller. Operation method: 1. Code pairing (learning) Place the original remote control and the copy remote control as close as possible first press a button of the original remote control and immediately after the indicator light turns on press and hold a button of the self-copy remote control for about three seconds the LED will flash 3 times and then quickly Flashing it means that the address code of the original remote control button has been learned successfully. The other keys are operated in the same way for learning. 2. Clear code Press the unlock button and the lock button at the same time for 2 seconds the LED light starts to flash 3 times. At this time keep the lock button pressed and release the unlock button. Press the unlock button three or four times within 5 seconds and the indicator light flashes quickly. The code has been cleared. Test whether the existing code of the remote control has been successfully cleared: When you finish the clearing action you can press any button of the copy remote control. If the LED does not flash immediately at this time it will flash after 2 seconds that means Copy the original code of the remote control has been completely cleared if the LED still flashes quickly it means that the code still exists and needs to be cleared again. 3. Restore the cleared code The copy remote control has a recovery function. If you accidentally clear the address code of the normal copy remote control during use you can press the start and mute buttons (the next two buttons) on the remote control at the same time. After about three seconds the LED will flash 3 times. It starts to flash quickly which means that the cleared address code is successfully restored. Tips: 1. Before using our copy remote control to copy first clear the existing code of the self-copy remote control. 2. The self-copy remote control cannot copy the rolling code such as HCS301. Note: Due to the different monitor and light effect the actual color of the item might be slightly different from the color showed on the pictures. Thank you! Please allow 1-2cm measuring deviation due to manual measurement. Included: 1 X Copy Key D