For Nintendo Switch Wireless Controller with Turbo Dual Vibration, Grey, 501 Original

For Nintendo Switch Bluetooth Controller Wireless Wired Gamepad with Turbo Dual Vibration Replacement for Joy ConFeature:Support dual vibration/gravity induction/acceleration induction/Turbo, etc.Ergonomic design, you will not feel tired even if you hold it for a long time.Specification:Color: Red, Blue, Black, Grey, Yellow, Green (Optional)Product weight: 223gProduct size: 175*125*40mm/6.89*4.92*1.57\\\"Instruction:When connecting and pairing for the first time, please follow the steps below:1. Open the Switch console2. Install the controller on the Switch console, and use the slide on the side of the console to slide the controller from top to bottom until you hear a slight click3. The controller starts to automatically register and pair. After the pairing is successful, it can be plugged into the console for use, or it can be removed and connected via Bluetooth.After the controller is installed on the console, the pairing cannot be registered. Please refer to the following methods to check the pairing problem:1. Make sure your console has been upgraded to the latest system2. Press the pairing button to close the controller, reset the connection of the controller, and then plug the controller into the console3. Insert the controller into the console, make sure that the direction of insertion is correct, it slides to the end, and a slight click sound is heard4. Unplug the controller from the console, try to insert it again, and rule out the failure to pair because there is no good contact5. If the controller cannot be awakened, please charge your controller before trying to pairHow to pair (connect back) the controller to NSW againAfter the controller is paired for the first time, you can connect the controller to the console again in the following two waysMethod 1: Bluetooth connection and pairing1. Turn on the Switch console2. Press any function key (except the joystick) for 2 seconds to wake up the controller, and then the controller will automatically pair with the console via Bluetooth. The pairing can be completed in about 4 seconds.3. Once the pairing is successful, the corresponding LED indicator of the controller will be onMethod 2: Wired connection and pairing1. Open the console2. Attach the controller to the console through the slide on the side of the console3. After that, the controller will automatically pair with the console via wired connection, and the pairing can be completed in about 4 seconds.Pairing troubleshooting:When the controller is inserted into the console, it cannot be paired, please refer to the following method to check the paired controller or methodMethod 1: Delete the pairing information of the Switch console1. On the main interface, select (Settings), then click (controller and Sensor), and select (Disconnect the controller)2. Long press the X key of the controller to disconnect this console from all controllers and unmatch3. Pair all the controllers that need to be used againMethod 2: Press the pairing button of the controller, reset the connection of the controller, and pair againRemove the controller from the console, press the pairing button of the controller, reset the connection of the controller, and pair the controller to the console againMethod 3: Make sure that the controller has been slid into the slideway of the console in the correct way, and slide the controller to the endMethod 4: Charge your controller, because the battery of the controller must be kept at low power during transportationWhen you get the controller, the controller may be in a low power state and cannot be turned onMethod 5: Make sure the console is the latest systemMethod 6: Try to remove the controller from the console and connect it againNote:There may be slight size deviations due to manual measurement, different measuring methods and tools.The picture may not reflect the actual color of the item because of different photographing light, angle and display monitor.