FYS Heated Bed Auto Leveling Sensor Starter Kit ABL kit fits Ender-3 for 3D Printer

Description 1 The Ender 3 ABL kit is only for the complete automatic bed leveling kit for the Ender 3 Ender 3 PRO 3D printer 2 Suitable for all printed surfaces glass aluminum substrates and removable building surfaces 3 Complete and simple flash firmware and installation instructions with all required software and compiled binary hex files 4 Capacitive sensor can be used on any printed surface5 Pre wired electronic equipment can be placed in the custom enclosure6 Our sensors are optically isolated so even when failure occurs you will not have the risk of burning down the printer s motherboard which is different from the diode or resistor settings 7 The sensor has been connected to the optical isolation module you only need to connect 2 wires and replace the Z min connector 8 Including an icsp programmer for programming firmware 9 U disk content firmware burning software installation and use instructions drivers etc 10 Our sensors are photoelectrically isolated so unlike diode or resistor settings you don t have to risk burning the printer s motherboard when a fault occurs Package Included 1 ABL Kit