Electric Cloning Universal Gate Garage Door Opener Remote Control Fob 433mhz Replacement Key Fob

One-to-one duplicate keys Each password lock itself storage Can copy repeated continuously using one million times Strong privacy Product Specifications: Working voltage: DC12V (27A battery included) Operating current: ¡Ü 8mA Working frequency: 433.92 MHz (315 MHz optional) Modulation mode: ask (am) Power transmission: ¡Ü 100 mw Emission distance: 50 to 100 m (evidence) Type encoding: copy themselves Working temperature: -10 ¡ã C to + 50 ¡ã c The following works by remote control ic modules (please check your original remote control before ordering) and you also have to keep remote code or learning code. 2262.2260 5026.5326 5326-3 5326-4 fp527 PT2240 ev1527 HT6010 HT6014 ht12e HT640 ht680 PLC158 PLC008 SMC918 SMC926 PT2292 12L-4SC HT6026 UM3750AM etc. Use: garage door motorcycle car alarm products home security products short-range wireless remote control products industrial control products Note: An essential condition for the selection of the remote control; copyed remote control to operate normally the chips are compatible and frequency are correct. Before buying make sure the copyed remote control operating frequency or choose & buy adjustable frequency remote control. Before buying please confirm whether your remote control can be copyed or not. Remote control we can copy fixed code and learning code Instead of stealth code. it can copy original remote control car remote control and two-way remote control rolling code (rolling code chip begin with HCS common such as hcs200 hcs201 hcs300 hcs301 etc.) Note: It copies the remote control can not copy the computer code and rolling code the device can only copy fixed code or learning code. How to Program : Step 1 – delete the existing code of our remote duplicator 1)Click and Hold A and B buttons together - Led will flash 3 times 2)Keep holding A button and release B button 3)Keep holding A button and push B button 3 times Led will start flashing Non-stop Now press any key on the remote control LED lights are not bright so delete code success; if you press the button LED lamp is lit indicating that the original code is not deleted ! Step 2 - clone your original remote 1)Put both remotes Into back to Back position. Make sure they have direct contact 2)Click and hold 1 button on your original remote and 1 button on your clone remote. Keep holding until led will make 2 blinks then 3 blinks then goes into Steady and you have successfully cloned. ( the left keys follow the same above operation) If for some reason the clone does not go further then 2 blinks it means the signal does not go through please shift the remote slowly up and down until you get the point where it will go through.