E300 Car HUD Head Up Display 5.5 inch with OBD OBD2 Interface Plug

E300 Car HUD Head Up Display 5.5 inch with OBD OBD2 Interface Plug HUD Main Feature: 5.5” screen. 2D visual effect. Auto power on and off with the vehicle. Automatic and manual brightness adjustment mode. Plug and Play connectivity with any OBDII or EUOBD capable vehicle. Multi colour design makes the screen easier to read highlight important details for quick viewing. The use of nanotechnology to eliminate unwanted reflections making the information easier to read. Ability to display a huge range of car statistics including: speed, engine rotational speed, water temperature, battery voltage, instantaneous fuel consumption, average fuel consumption, local time,single driving time,mileage measurement, shift reminder, fatigued driver reminder, low voltage alarm, high temperature alarm, speed alarm, engine fault alarm, fault code elimination, ability to change units e.g. Kilometre/mile. HUD Installation Procedure: 1. Ensure your vehicle is OBDII compatible or EUOBD. a. Check around the area under the steering wheel for an OBD plug b. Contact your vehicle manufacturer or search online c. Open the bonnet and look for a OBDII compatible sticker (this is NOT on all OBDII compatible cars, therefore isn’t a deciding factor) 2. Locate the 16 pin diagnostic link. This is usually located in the area under the steering wheel. 3. Start vehicle’s engine and ensure power switch is in the on position. 4. HUD will power on with engine a. If the HUD displays vehicle voltage, fuel consumption, speed and rotational speed the unit has installed correctly. b. Failing the above: Wait up to one minute for software to sync and confirm OBD cable is plugged in properly. Reflective Film Installation: 1. Place the supplied non-slip mat in the desired position on the dashboard with the HUD on top. 2. Observing where the HUD reflects place the reflective film in position. a. Ensure the surface is clean and dry before installing the film; b. Remove the back protective side marked (1) and attach the film to the clean windscreen; c. Once you’re satisfied with the location use a credit card or similar to remove any bubbles or air pockets that remain; d. Remove the front side marked (2), if you need to adjust the HUD’s reflection, reposition using the nonslip mat. Technical Parameter: Environment Temperature -40℃ ~ +80℃ Barometric Press 86 ~ 106KPa Relative Humidity 10% ~ 95% Environment Noise ≤60dB Alarm Decibel ≥30dB(A) Work Voltage 9V ~ 16Vdc(12Vdc/400mA) Product Dimensions 12.5 * 7.5 * 1.5(cm) Product Weight 110g Package Included: 1 X E300 Head Up Display 1 X Reflective Film 1 X OBD Connecting Line 1 X User Manual