Dual DC Current 12V/24V Solar Controller LCD PWM Photovoltaic Power Generation Controller(10A)

Parameter1. System voltage: 12V/24V automatic adaptation2. Rated charging current: 10A3. Rated discharge current: 10A4. Photovoltaic voltage: 23V for 12V battery; 46V for 24V battery5. Boost charging voltage: 14.4V6. Float voltage: 13.7V (default, adjustable)7. Discharge cut-off voltage: 10.7V (default value, adjustable)8. Discharge recovery voltage: 12.6V (default value, adjustable)9. Charging recovery voltage: 13V10. Photovoltaic panel: 8V for light-controlled light-on threshold (the light-controlled light has a delay)11. Photovoltaic panel: 8V for light-controlled turn-off threshold (there is a delay for light-control turn-off)12. USB output: 2 USB outputs, 5V/2.5A13. Standby current: less than 10mA14. Working temperature: -35 to 60 degrees Celsius15. Size: 125x112x34mm16. Weight: 179gFeatures1. Adopt industrial-grade main control chip2. Large-screen LCD display; charging and discharging current display; cumulative power generation and discharge power query; temperature display; light control + delay control; adjustable charging and discharging parameters; with power-off memory and other functions3. Dual USB output, current up to 2.5A, support Apple mobile phone charging4. Complete 3-stage charging management5. Built-in over-current, short-circuit protection, open-circuit protection, and reverse connection protection, all of which are self-recovery and will not damage the controller6. Anti-backflow circuit, ultra-low heat generation.System connection1. Connect the positive and negative poles of the battery to the controller as shown in the figure, and the controller will automatically detect the battery voltage2. Connect the positive and negative poles of the load to the controller according to the diagram, and be careful not to reverse them3. Connect the solar panel to the controller according to the pictureSafe use advice1. The controller is 12V/24V automatic recognition, when installing for the first time, please make sure the battery has enough voltage so that the controller can recognize the correct battery type2. Install the controller as close to the battery as possible to avoid voltage drop caused by too long wires and affect normal voltage judgment3. This controller is only suitable for various lead-acid batteries (including open, sealed, gel, etc.)4. This controller can only use photovoltaic panels as the charging source, do not use DC or other power sources as the charging source5. The controller will generate heat during operation, please pay attention to install the controller on a flat and well-ventilated surface