Dheera Desoldering Pump Manual Solder Sucker with Sponge Cover Portable Tin Sucker

Features: 1. The tin suction pump is made of high-quality ABS material which is heat-resistant reusable and durable. 2. Ergonomic handle design comfortable grip non-slip sponge handle easy to operate. 3. Double-ring air leakage protection: Adopt double sealing ring design with strong suction which can effectively avoid air leakage. 4. The tin suction device is designed with an anti-rust pull-back spring with large suction and high efficiency. 5. Small and compact easy to carry. It can be put into a bag or pocket without taking up space. Notice: 1.Actual color may be slightly different from the image due to different monitor and light effect 2.Please allow 1-3cm deviation due to manual measurement Description: Material: ABS with sponge cover Size: 210*21mm Use method of tin sucker: 1. Press the piston of the tin sucker down until it is stuck. 2. Heat the solderjoints with an electric soldering iron until the solder melts. 3. While removing the soldering iron quickly paste the solder joint on the nozzle of the solder suction device and press the button of the solder suction device. 4. It cannot be sucked clean at one time and can be operated repeatedly. Using skills: 1. To ensure good solder sucker piston seal. Before electricity with your fingers to plug hole solder sucker head solder sucker head to press the button if the piston is not easy to pop into place that the seal is good. 2. The aperture tin suctioner heads are of different sizes select the appropriate specifications. 3. Tin suctioner head wears should replace the new one. 4. Solder paste is dipped in a little bit of rosin before contact with solder to improve solder fluidity. 5. Head contact pads are slightly longer when solder melts the solder joint pin as the center then hand out in a clockwise direction to draw a circle and then press the button tin suctioner.