DENEST High-quality ABS Pipe Blockage Detector Emitter Strong Signal Penetration 30M

Description Are you still wasting a lot of time because your pipes are clogged but you can t find the blockage? This pipe blockage detector uses the principle of electromagnetic induction the transmitter probe emits electromagnetic waves and the receiver receives electromagnetic waves to accurately find the blockage. It is suitable for various scenarios where the pipes are clogged due to various reasons. Details Soft Signal Wire: The signal wire is very soft wear-resistant not easy to break smooth and easy to cross the curves. Horn Design: When closer to the blockage the sound from the horn will be louder and clearer to remind you. Depending on the distance from the blockage the sound will also vary. Wheel Design:The signal line can be easily tucked into the wheel organizer. This type of wheel design will save you a lot of effort and won t get your hands dirty. Anti-slip Grip: Both the transmitter and receiver have anti-slip grips which can effectively prevent slippage during operation and facilitate use. Headset:This pipe blockage detector comes with a headset that you can use in noisy environments or long-distance detection which is very thoughtful Storage Bag: Our pipe blockage detector comes with a storage bag you can put the detector and accessories together in the storage bag which is very convenient to carry. Application This product can be used to detect blockage in iron/PVC/cement/plastic/steel/copper pipes etc. in engineering. Specification Style: Simple Modern Material: ABS Color: Red Standby Time: 7-8 Hours Transmitter Battery Capacity: 2600mAh Receiver Battery Capacity: 1400mAh Sensable Wall Thickness: 40cm/15.7inch Signal Line Length: 30m/98.43ft Transmitter Size: 30*36*4.5cm/11.81*14.17*1.77in Receiver Size: 36*6.5*4cm/14.17*2.56*1.57in Package Size: 40.2*36.5*8.4cm/15.83*14.37*3.31in Net Weight: 2.4kg/5.29lbs Gross Weight: 2.5kg/5.51lbs How to Use Pass the signal line and transmitter head into the pipe until the signal line can not advance at this time the position of the probe is the blockage position! Open the signal transmitter power switch the red light indicator lights up! Turn on the signal receiver switch and then take the signal receiver to detect along the general direction. If close to the probe in the pipe the horn will sound. The loudest place is the blockage point. Make a mark pull out the signal line and then chisel the ground to deal with blockage! If in the test the green light flashes indicating that the power is insufficient please charge in time. Package Included 1* Pipe Blockage Emitter 1* Pipe Blockage Receiver 1* Charging Cable 1* Headphone 1 Box* Probe Accessories 1* Storage Bag 1* English Manual Notes Please be aware to lift the instrument with your left hand and turn the hub forward/reverse with your right hand to dispense and rewind the wire. Do not pull the signal wire by force otherwise this may cause the signal cable to be stuck or torn off. Please allow the slight color difference caused by the shooting light and 1-3 cm error due to manual measurement and make sure you do not mind before ordering.