DC PWM Motor Speed Controller Module LED Digital Display Switch Accelerate Decelerate Speed Control Regulator DC8V-55V

Specifications Voltage DC8V 55V wide voltage anti back protection Speed range long press short press to adjust the degree 0 100 speedDrive current up to 10A recommended output series 12A fuse Standby current 17mAMounting hole diameter 3mmProduct size 64mm 35mm 19mm length width height Working temperature 20C 70CFeatures 1 The digital tube flashes at the moment of power on normal phenomenon no need to worry 2 close to the limit drive current working conditions it is recommended to take the output end of the fuse3 The DC motor speed controller cannot be installed in places where there is dripping water and children can reach it 4 After wiring check if the line is correct and then energize so as to avoid accidentally burning the temperature controller and load device Wiring M and M are respectively connected to the positive and negative terminals of the output M is positive and M is negative VIN and GND are respectively connected to the positive and negative terminals of the input terminal Vin is positive and GND is negative input power supply voltage is DC8V 55V Instructions 1 Click long press the speed increase button to increase the motor speed to 100 2 Click long press the speed down button to increase the motor speed to a minimum of 0 3 Press and hold the Power On Off button for one second the controller will be turned on or off the power is turned off by default and the memory function is activated after booting Package I