Crimping Pliers For Cable Lugs -Sn-28B Crimping Pliers Socket Terminal Crimping Pliers For

Features: Small gripper feel good. Automatic buckle lock more powerful. Ratchet - type force - connecting rod structure. Can be adjusted by adjusting the crimping force of the wheel control handle. Easier operation faster pressure driving. This crimping tool can be used for crimping male and female crimp pins onto 18-28 AWG wire to create custom cables. Specification: Condition: 100% Brand New Color: Blue + Black Material: Alloy Steel Ni-Cr Size: (L) x (W) 190 x 150mm/7.48 x 5.51 (Approx.) How to use: 1.If on a roll do not cut the pins leave - them until wire is crimped. Prepare the wire by stripping approximately 1/8 (3mm) of insulation from the end. Place the wire into the crimp pin aligning it so that the stripped part is between the inner set of tabs on the crimp pin while the insulated wire is between the outer set of tabs. 2.If your crimp pins are too short for this method see the bottom of these instructions for an alternative. Place the wire and crimp pin on the appropriate prong e of the tool die making sure the insulated end is on the raised wider half of the tooth. Tabs should point towards the cavity on the other side of the die so that the tool bends them inward around the wire when it closes. 3. Close the jaws of the tool slowly and completely until what they release. The tabs on a properly crimped pin should form a barrel around the leads