BAMILL JJY1060N Receiver Module Radio Time Module Radio Clock Radio Module Antenna

describe: DCF receiver module with DCF antenna tuned to time signal transmitter DCF77 (Frankfurt 77.5 kHz). The antenna induction signal is sent to the IC for amplification demodulation and then identified by the MCU so that the date and time of the timing center are completely consistent. Below you will find important setup and circuit diagrams. Technical Specifications Product number: JJY-1060N-MJU RCCM category: JJY/40+60KHz dual frequency module PCB size: 35.0x18.0x1.0mm/FR4 Antenna size: AR10x60mm/High Q Nominal frequency: 40/60KHz±300Hz Sensitivity: 40/60K:30/28±2dB Receiving IC: MAS6181B • Operating voltage: 1.1...3.3 V • Current consumption: 85 µA max • Receiving frequency: 77.5 KHz • Board size (without antenna) LxWxH: 22x13.5x1 mm • Antenna quality: LxØ: 60x10mm • Scope of delivery: 1 piece ⇒ DCF receiver module with antenna • connect: ⇒ Ground = Pin G ⇒ Operating Voltage = Pin V ⇒ data = pin T ⇒ Power On/Off = Pin P1 • Important note: ⇒ PIN P1 is an on/off switch and must be set to logic low. 1. 40/60-frequency selection 60KHz--LOW 40KHz--HIGH; 2. RF - reverse output time signal; 3. PON-power control pin LOW is valid HIGH is standby; 4. AGC-AGC control pin; 5. GND-connect to the negative pole of the power supply; 6. VDD- connect to the positive pole of the power supply; Note: Single-frequency modules cannot be switched between different frequencies of DCF/WVB/HBG/BPC JJY dual-frequency modules can be switched between 40K/60K two frequencies to make a certain single-frequency module only can receive signals in this frequency band. Package Included: 1*Receiver module