8g 30.5x30.5mm Holybro Kakute F7 HDV Flight Controller STM32F745 with Barometer compatible with DJI Air Unit for RC Dron

OverviewHolyBro Kakute F7 HDV is designed to work with the DJI FPV VTx module. The GH port available on the board makes it much more convenient for you to connect HolyBro Kakute F7 HDV to the DJI FPV VTx, for both signal and power.Specifications:MCU: STM32F745 32-bit processorIMU:PMU6000Barometer: BMP280USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)6 hardware UARTS (UART1,2,3,4,6,7)All UARTS support hardware inversion. SBUS, SmartPort, and other inverted protocols work on any UART without uninvert hack.Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.TF card for Blackbox loggingDimensions: 35x35mmMounting Holes: Standard 30.5mm square to center of holesWeight: 8gFeatures: Supports Betaflight, Butterflight, and Cleanflight. High-performance / low-noise IMU. MPU6000 with 6-axis gyro and accelerometer.Ready for autonomous flight: Integrated BMP280 barometer and SCL/SDA for use with external GPS/magnetometer units. Dedicated bootloader button for easy firmware flashing. Low-profile design fits into even very compact frames. Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on B+ pad only). Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the KAKUTE F7 HDV monitors voltage directly from the power supply. Filtered voltage output for clean, noise-free video. 2 On-board regulators output 5V and 8V. 5V output up to 1.5A to p