300*300mm PEI Magnetic Flexible Hotbed Surface AB Side Heated Bed Sticker with Magnetic Block for CR-10/CR-10S/Anet E10/

Description No more 3M Masking tapeNo more glue sticNo more ABS juiceNo more PEI sheet replacementEasy to printEasy to remove by bending and popping it offEasy to maintainDouble sidedLower runing costespecially for printing farmGenuine PEI powder coatingHardened steel spring sheet never deformingMake adding inductive Z probe possiblePossible to adding ABL for some low cost printers Specification Size 300x300mmMaterial Compatibility PLA ABS PETG TPU PVA etcPrinter Compatibility Anet A8 A6 E10 E12 Creality Ender 5 CR 10 CR 10SMaintenance Wipe the print surface before and after a print with isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength As with any build surface make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface If printing PETG TPU TPE and RYNO make sure the bed is heated BEFORE attempting to remove the print from the bed B plate with 3M adhesive stick on the build surface Please Kindly Note the plate is magnetic the temperature recommended from 50 to 80 degrees centigrade should not exceed 80 degrees so It is not suitable for ABS if set heated beyond 80 degree it s magnetism will be weaker Note Due to the size of the product is huge In order to control the strength of the bend We maintain a relatively thin thickness So it is not flat when it is not magnetically adsorbed When it is placed in a magnetic bed it will be magnetically adsorbed so that it wil