3 PCS Electrician Automatic Stripping Parallel Terminal Winder, Model: Electric / Manual Version

1. No peeling, automatic merging, labor-saving and convenient2. The electric must be used with an electric drill, and the vise should be clamped tightly against the wire bender3. Parallel three or more wires need to use a 16V or more electric drill4. Durable, sharp double-edged, comfortable to hold5. Only one wire can be inserted into each inlet hole6. Stainless steel galvanized, long service life7. Stainless steel blade, sharp slices, no residue8. High temperature quenching, high hardness, five holes and clamp9. Material: stainless steel galvanized10. Note: Applicable to 2.5-4 square national standard BV single-strand hard wire, non-national standard, multi-strand, not applicable11. Scope of application: electrician maintenance and assembly, wire and wire processing, metal wire and wire12. Weight: about 80gInstructions:1. Fix the wire bender on the electric drill, arrange the wires neatly and clamp it in a vise2. Align the wire with the corresponding wire slot, and be sure to be close to the front of the wire doubling device when clamped in a vise3. Start the electric drill, press a bit of strength to the front, rotate it for about one second, and pull it out slowly4. Warm reminder: please pay attention to safety when using and don't pull it hardPrecautions:1. This product is not suitable for the combination of high-hardness wires such as steel wire/iron wire/alloy wire and other hard materials2. Do not parallel wires containing strong acid and strong corrosive wires. Please keep clean after use to prevent corrosion