1 Set MA/AR Chassis Modification Kit FRP Part For Tamiya Mini 4WD RC Car Parts Without Wheel Tire

Using way Installation tool tire puller tire loader screwdriver nut sleeve 1 mm hand drill using a hand drill before drilling a large screw Faucet assembly The first step remove the front and rear guides and rear brakes of the original carStep 2 Unpack the faucet kit1 Locate the faucet and compare the screw holes to the corresponding holes 2 Screws pass from bottom to top through the chassis and faucet3 Plus nut fixing4 Add the order on both sides so that the gasket protrusion head upwards bearing shaft guide wheel copper tube double guide wheel bearing shaft gasket protrusion head down 6mm aluminum tube wave head Install in order the same on the other side Middle wing installation The first step is to open the middle wing bag pass the screw through the corresponding hole in the middle wing fix it with a nut then put it into the big nail head In the second step the middle wing is fixed to the chassis and the middle wing is mounted on the chassis from the bottom and the small screws of the middle wing bag are taken out and the middle wing is fixed to fix the chassis The third step after fixing the screw the upper nutTail installation 1 Remove the rear guide wheel and the bearing shaft and use the tire puller to drive the bearing shaft into the guide wheel from bottom to top gasket gasket aluminum tube nut aluminum tube gasket gasket wave head2 the order of the fittings of the tail is screw shield protrusion head up guide wh