1-30L/min High Water Hall Sensor Water Sensor Repair Repalcement For Judge Water Amount Adjusts

1-30L/min High Water Hall Sensor Water Sensor Repair Repalcement for Judge Water Amount Adjusts Specification: Description: Water sensor is mainly composed of plastic valve water rotor subassembly and hall sensor.It is mounted on water heater inlet and used to meter water . When water goes through rotor subassembly magnetic rotor rotates and rotating speed changes with the . Hall sensor outputs corresponding pulse signal as feedback to controller and controller judges water amount and adjusts . Features: This sensor meter is lightweight small and easy to install. The internal impeller has stainless steel shaft which is quite wear-resistant. uses mechanical structure that stressed from up and down directions and will not leak. The sensor has Hall effect and is encapsulated with glue preventing from water entering. It is a great sensor of high long service life and stable performance. Specifications: Working Range: 1~30L/min Water Pressure: Less than or equal to 1.75MPa Pipe Thread: G1/2 DN15 Thread Outer Diameter: Approx. 2cm Output Waveform: wave Size: 6.1x3.4cm/2.4x1.3in Wiring: Red: IN+ Yellow: OUT signal output Black: GND- Note: 1 Forbidden to severe impact and chemical erosion. 2 Forbidden to throw or collision. 3 Water detection should be same as the on sensor. 4 Water temperature should not be more than 120 degrees Celsius . Package Includes: 1 x Sensor