Stepper Motor Driver Large Torsion DC10V-26V Motors Drive Controller High Speed For Automation Equipment

Stepper Motor Driver Large Torsion DC10V-26V Motors Drive Controller High Speed for Automation Equipment Specification: Item Type: Stepper Motor Driver Model: SMD-1524-M32S-TV10 Specification: 4 phase 5 wire unipolar type Speed Response Rate: 100KHz Operating Temperature: 0-50 degrees Celsius Operating Humidity: 40-90% Input Voltage: DC10V-26V Input Current: > 5A Allowable Input Power Ripple: Less than or equal to 50MV 1. Wiring Method: GND: DC power supply earth wire +V: DC power supply positive pole range 10V-26V recommended value +24VDC A+ A-: A phase coil of the motor B+ B-: B phase coil of the motor VM: Motor coil power supply pin which is connected to V+ pin in the positive direction 2. Control Signal Interface Function: PUL++5V PUL-PUL: Pulse Control Signal: The rising edge of the pulse is valid; PUL is 4~5V at high level and 0~0.5V at low level. In order to reliably respond to pulse signals the pulse width should be greater than 1.2μs. If +12V or +24V is used a series resistance is required; 12V series 1K ohm 0.25W resistance 24V series 2R ohm 0.5% resistance. DIR++5V DIR-DIR: Direction Signal: High low level signal. To ensure reliable commutation of the motor the direction signal should be established at least 5μs before the pulse signal. The initial running direction of the motor is related to the wiring of the motor interchange any phase winding such as A+ A- exchange can change the initial running direction of the motor DIR- high level 4~5V low level 0~0.5V; 12V string 1K ohm 0.25W resistor 24V string 2R ohm 0.5% resistor. ENA++5V ENA-ENA: Enable Signal: This input signal is used to enable or disable. When ENA+ is connected to +5V and ENA- is connected to low level or the internal optocoupler is turned on the driver will cut off the current of each phase of the motor to make the motor in a free state and the step pulse will not be responded at this time. When this function is not needed the enable signal terminal can be left floating; if +12V or +24v is used a series resistance is required 12V series 1K Ohm 0.25W resistance 24V series 2R Ohm 0.5% resistance. Package List: 1 x Stepper Motor Driver Note: Do not place it to other heat generating equipment avoid dust oil mist corrosive gas places with high humidity and strong vibration and prohibit flammable gas and conductive dust.