Smart MTB Bicycle Headlight USB Rechargeable Horn Waterproof Ultralight, Black, 501 Original

4000mA Smart Induction Power Indicator Mutiple-Uses Cycling Bicycle Front Light USB Rechargeable 1000 Lumen Horn Flashlight MTB Waterproof Ultralight Portable ConvenientFeature:Horn + headlight double wire control design, aluminum alloy lamp cap, intelligent dimming, 2 T6 bright lamp beads.The intelligent mode can be switched, and the built-in light sensing chip can automatically adjust the brightness according to the light intensity of the riding environment, effectively saving power.The independent pluggable wire controller is connected through the USB port, and the hand can not leave the handle to control the light and horn during riding, which is convenient and greatly improves the safety of operation during driving.Various lighting modes can be switched according to different environments. They are riding headlights and flashlight.Integrated 120 dB horn, 5 kinds of sound can be switched, independent split wire control switch, pluggable design.4000 mA high-capacity battery, which lasts about 6 hours in high light and 20 hours in low light. Support external charging treasure to be used while charging.Aluminum alloy texture lamp cap, compression resistance, fall resistance, better heat dissipation and longer service lifeWaterproof design, which can be used in rainy days. Wipe it dry in time after application. It is not recommended to use it for a long time in rainy days. It is not allowed to soak in water.4-segment power indicator, real-time control of endurance, the charge is clear.Specification:Lamp bead: T6 * 2Battery capacity: 4000 mALumens: up to 1000lmWeight: about 220gSize: 100*51*28mm/3.94*2.01*1.1inLighting mode: highlight, intelligent, flash, low lightControl: double wire control + buttonHorn: 120 dB (5 kinds of sound can be switched)Installation steps:Put the rectangular gasket into the middle of the bottom seat to reinforce and protect the handlebar.Buckle the bottom seat on the handlebar and screw it up and down. Pay special attention not to screw it too tightly, which may cause the bottom seat to break.Align the front light of the host with the card slot and push it back into the bottom seat. At the same time, press the clip to make the convex point on the base correspond to the concave point on the host and lock it.Disassembly steps:Press the rear clip down.When pressing the clip, the convex point on the clip will pop up and separate from the concave point on the host. Only then can the host be pushed out. Push the host forward slowly out of the card slot.Note:Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!Please allow 1-2cm measuring deviation due to manual measurement.Package Content:1 Set X Aluminum Alloy Bicycle Headlight