DC DC 12v-36v 500w Brushless Motor Drive Controller Board with Hall Motor Balance Car Drive

Specification Working voltage DC 12V 36VWorking current 15ADriving power 500WSpeed ​​voltage 0 1V 5VWorking temperature 40 85CHumidity 90 RhStall Protection YesEnable Control YesOvercurrent Protection YesSteering Control YesSpeed ​​control signal yesSize 63 42 17mm length width height probe size is 3mm length the center distance of the fixed hole is 57mm width the center distance of the fixed hole is 36 5mmPower terminal output MA motor phase U MB motor phase V MC motor phase W GND negative supply VCC positive supply Set for the control side 5V 5V outputEL enable control terminal ground 5V OT ground then ground 5V motor stops Signal Tachometer pulse output depending on the number of motor poles corresponding to the number of pulses per revolution of the output digital Z F reversing control connect to 5V or ground to charge the motor in the direction of rotation VR regulator end 0 5V corresponding to 10 motor speed 100 GND Ground control terminalHall interface 5 volts the positive pole of the Hall power supplyHA Hall signal A UHB Hall signal B WHC Hall signal C WGround Hall NegativeInstall the wires Unit control terminal 1 Motor speed control wiring method the system speed of the available potentiometer can also be connected to the microcontroller for control When the potentiometer controls the wiring the middle pin of the potentiometer is connected to the VR speed port the two ends of the potentiometer are connected to 5V th